You are here
Search results
(1 - 2 of 2)
- Title
- Surface energy characterization and competitive surface equilibria using contact angle
- Creator
- Stubbs, Barrack Perez
- Date
- 2017
- Collection
- Electronic Theses & Dissertations
- Description
-
Surface energy measurements are usually difficult to assess when not considering a solid-air or liquid-air interface. Contact angles was used as a method of obtaining the interfacial energy of a silanol-water surface using carbon tetrachloride as a probing liquid. The theory for this work operated under the assumption that the pKa of a silanol surface could be measured by obtaining a titration like curve as a function of pH. A decrease in contact angle of about 7° was observed at a pH (pKa)...
Show moreSurface energy measurements are usually difficult to assess when not considering a solid-air or liquid-air interface. Contact angles was used as a method of obtaining the interfacial energy of a silanol-water surface using carbon tetrachloride as a probing liquid. The theory for this work operated under the assumption that the pKa of a silanol surface could be measured by obtaining a titration like curve as a function of pH. A decrease in contact angle of about 7° was observed at a pH (pKa) of 3.5. This corresponds to an energy difference of 2 mN/m. -- Abstract.
Show less
- Title
- Fundamental studies of competitive equilibria at silica surfaces
- Creator
- Stubbs, Barrack Perez
- Date
- 2019
- Collection
- Electronic Theses & Dissertations
- Description
-
"The fundamental interactions such as physisorption at solid-liquid interfaces are not fully characterized. The physical properties and chemical reactivity at the silica surface is one that is subject to much investigation. A variety of analytical techniques, including solid state nuclear magnetic resonance (SS-NMR ) and high-performance liquid chromatography (HPLC) were utilized to help characterize the surface of silica. These techniques were combined in order to understand the fundamental...
Show more"The fundamental interactions such as physisorption at solid-liquid interfaces are not fully characterized. The physical properties and chemical reactivity at the silica surface is one that is subject to much investigation. A variety of analytical techniques, including solid state nuclear magnetic resonance (SS-NMR ) and high-performance liquid chromatography (HPLC) were utilized to help characterize the surface of silica. These techniques were combined in order to understand the fundamental mechanisms of surface interactions such as adsorption mechanisms and chemical reactivity. The pH, ionic strength, and mobile phase compositions were varied throughout the experiments as a basis for assessing reactivity.The SS-NMR data shows a correlation between pH and labile surface hydrogens. At higher pH values, the transfer of excitation from labile surface hydrogens to surface silicon atoms is diminished. A change in peak ratios that correspond to labile primary silanols and surface bridging siloxanes was observed. The relative concentration of bridging siloxanes is constant whereas the signal from primary silanols is greatly diminished.Aqueous, normal-phase HPLC shows the various interactions of phenol with the silica surface. Multiple peaks were generated from a single analyte when the water/methanol concentration was at least 20%/80%. At 90% and 100% methanol, a single peak is shown for phenol. The ratio and number of peaks depends on conditions such as solvent composition, pH, ionic strength, flow rate, and temperature. We argue that the distribution of surface silanol sites is responsible for the generation of multiple peaks that are seen in the extreme aqueous conditions. These sites, as well as the water in the mobile phase, modify the mass transport term in the Van Deemter equation. The conditions and results obtained in these experiments are explained below with an emphasis on mass transport.Additionally, other analytical techniques such as scanning electron microscopy, thermogravimetric analysis, and inductively coupled plasma were used to help characterize the silica surface. Through these techniques, values for surface silanol concentration ranging from 1.6micromole/m2 to 7.0micromole/m2 were obtained. The physical morphology of the silica surface was also characterized before and after exposure to basic environments."--Pages ii-iii.
Show less